Flower Cart Spinner Card

To create your spinner card, lay out the pieces in your kit.

Layer and adhere the blue with green stripe panel and cart die cut to the center of the card front.

Adhere the "Fresh Cut Flowers" die cut to the top of the cart. Then, layer and adhere the cart base die cut and your desired framed sentiment die cut to the bottom of the cart.

After lining up your plaid awning die cut pieces so they are in the correct order, adhere the pieces to the off-white awning die cut.

Adhere the awning to the top of the cart. (Use the foam adhesive included in your kit, if desired.)

Layer and adhere the pole, sign base, and floral sign die cuts on the left edge of the cart. (Use the foam adhesive included in your kit, if desired.)

Add adhesive to the center back side of the tire die cut, and place the Spinner onto the adhesive with the smaller side down. (If you are using liquid adhesive, let the adhesive dry for a minute or two before moving to the next step.)

Add adhesive the back of the Spinner and adhere it to the lower left corner of the cart. (If you want a level base for the Spinner, trim the left corner from the cart base to make more room. Also, if you are using liquid adhesive, let the adhesive dry for a minute or two before moving to the next step.)

Layer and adhere red plaid with blue stripe panel and the oval journaling die cut to the center inside of the card.

Using tweezers and liquid glue with a precision tip, adhere the tiny flower die cuts to the flowers on the inside and and outside of the card, if desired.

Now your card is ready for spinning!

We hope you enjoyed creating with K.I.S. Kits!